Separation of Phosvitin from Egg Yolk without Using Organic Solvents

The objective of this study was to develop a new method to separate phosvitin from egg yolk without using organic solvents. Phosvitin was extracted from yolk granules using 10% NaCl or 10% (NH4)2SO4 (final concentration) and then treated with heat to precipitate the lipoproteins from the extracted solution. The optimal pH for the phosvitin extraction from yolk granules was determined, and the iron-binding ability of the extracted phosvitin (final product) was tested. Adding 10% (NH4)2SO4 disrupted the granules, and the subsequent thermal treatment at 90°C for 1 h precipitated low density and high density lipoproteins, which enabled separation of phosvitin by centrifugation. The phosvitin concentration in the extract was significantly higher when the pH of the solution was adjusted to pH ≥9. The purity and recovery rate of phosvitin at the end of the separation process were approximately 78% and 56%, respectively. The separated phosvitin was confirmed to have ferrous and ferric iron binding ability. The advantages of this new method compared with the traditional methods include no organic solvents and high-priced equipment are needed for the separation. Also, this method is more environment and consumer friendly than that of the traditional methods

Concomitant Laparoendoscopic Single-Site Surgery for Vesicolithotomy and Finger-Assisted Single-Port Transvesical Enucleation of the Prostate

Transurethral resection of the prostate is the most common surgery for benign prostatic hyperplasia. However, it doesn't work best for men with very large prostate and bladder stones. Herein we report our initial experience with concomitant laparoendoscopic single-site surgery and finger-assisted single-port transvesical enucleation of the prostate for the treatment of the condition

Tuning of undoped ZnO thin film via plasma enhanced atomic layer deposition and its application for an inverted polymer solar cell

We studied the tuning of structural and optical properties of ZnO thin film and its correlation to the efficiency of inverted solar cell using plasma-enhanced atomic layer deposition (PEALD). The sequential injection of DEZn and O2 plasma was employed for the plasma-enhanced atomic layer deposition of ZnO thin film. As the growth temperature of ZnO film was increased from 100 ??C to 300??C, the crystallinity of ZnO film was improved from amorphous to highly ordered (002) direction ploy-crystal due to self crystallization. Increasing oxygen plasma time in PEALD process also introduces growing of hexagonal wurtzite phase of ZnO nanocrystal. Excess of oxygen plasma time induces enhanced deep level emission band (500 ??? 700 nm) in photoluminescence due to Zn vacancies and other defects. The evolution of structural and optical properties of PEALD ZnO films also involves in change of electrical conductivity by 3 orders of magnitude. The highly tunable PEALD ZnO thin films were employed as the electron conductive layers in inverted polymer solar cells. Our study indicates that both structural and optical properties rather than electrical conductivities of ZnO films play more important role for the effective charge collection in photovoltaic device operation. The ability to tune the materials properties of undoped ZnO films via PEALD should extend their functionality over the wide range of advanced electronic applications.open2

Enhanced Electrokinetic Transport of Sulfate in Saline Soil

The electrokinetic transport of sulfate was investigated as a means of treating and restoring a sulfate-accumulating saline soil. The electrokinetic treatment decreased the electrical conductivity of the soil, an indicator of soil salinity, to 58.6%, 73.1%, and 83.5% for 7, 14 and 21 days, respectively. More than 96% of the chloride and nitrate were removed within 7 days. However, the removal of sulfate was highly influenced by the anode material. An iron anode removed sulfate effectively, whereas, sulfate was hyper-accumulated in the anodic region when an inert anode was used. The iron anode was oxidized in a sacrificial anodic reaction, which competed with the electrolysis reaction of water at the anode, and finally the reaction prevented the severe acidification of the soil in the anodic region. However, the competing reactions produced hydrogen ions at the anode, and the ions were transported toward the cathode, which, in turn, acidified the soil, especially, in the anodic region. The acidification switched the surface charge of the soil from negative to positive, increasing the interaction between the soil surface and sulfate, and thus inhibiting the transport of sulfate under the electric field. The zeta potential analysis of the soil provided an explanation. The results indicate that preventing severe acidification is an important factor which influences the transport of anions and iron anode for the enhanced removal of anionic pollutants by electrokinetic remediation

New Preamble Design for Reduced-Complexity Timing Acquisition in UWB Systems

Abstract-Low-complexity rapid timing acquisition is one of the most pivotal challenges in ultra-wideband (UWB) wireless technology whose short duration pulse results in high resolution in time. In this paper, we propose a new preamble which can reduce the performance degradation caused by diminishing the operational complexity of the coarse timing acquisition. In the reduced-complexity acquisition algorithm, the received preamble is shortened by summing its elements group-by-group and correlated with the known PN sequence having reduced length to find the maximum output value of the correlators. This acquisition algorithm introduces performance deterioration since it loses the impulsive autocorrelation property of the PN sequence after summation. Therefore, we judiciously design a new preamble sequence whose slide correlator output function shows a distinct peak at zero delay and the symmetry even after summation. Simulation results demonstrate that the reducedcomplexity acquisition algorithm exploiting the proposed preamble outperforms the algorithm using the PN sequence as the preamble, while the amount of computational reduction remains the same

Application of the Whole Genome-Based Bacterial Identification System, TrueBac ID, Using Clinical Isolates That Were Not Identified With Three Matrix-Assisted Laser Desorption/Ionization Time-of-Flight Mass Spectrometry (MALDI-TOF MS) Systems

Background: Next-generation sequencing is increasingly used for taxonomic identification of pathogenic bacterial isolates. We evaluated the performance of a newly introduced whole genome-based bacterial identification system, TrueBac ID (ChunLab Inc., Seoul, Korea), using clinical isolates that were not identified by three matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF MS) systems and 16S rRNA gene sequencing. Methods: Thirty-six bacterial isolates were selected from a university-affiliated hospital and a commercial clinical laboratory. Species was identified by three MALDI-TOF MS systems: Bruker Biotyper MS (Bruker Daltonics, Billerica, MA, USA), VITEK MS (bioMerieux, Marcy l'Etoile, France), and ASTA MicrolDSys (ASTA Inc., Suwon, Korea). Whole genome sequencing was conducted using the Illumina MiSeq system (Illumina, San Diego, CA, USA), and genome-based identification was performed using the TrueBac ID cloud system (www.truebacid.com ). Results: TrueBac ID assigned 94% (34/36) of the isolates to known (N=25) or novel (N=4) species, genomospecies (N=3), or species group (N=2). The remaining two were identified at the genus level. Conclusions: TrueBac ID successfully identified the majority of isolates that MALDI-TOF MS failed to identify. Genome-based identification can be a useful tool in clinical laboratories, with its superior accuracy and database-driven operations.

Respiratory viral infections and the risk of rheumatoid arthritis

Background We aimed to investigate the effects of ambient respiratory viral infections in the general population on rheumatoid arthritis (RA) development. Methods Data of weekly incident RA (2012–2013) were obtained from the Korean National Health Insurance claims database, and those of weekly observations on eight respiratory viral infections were obtained from the Korea Centers for Disease Control and Prevention database. We estimated the percentage change in incident RA associated with ambient mean respiratory viral infections using a generalized linear model, after adjusting for time trend, air pollution, and meteorological data. Results A total of 24,117 cases of incident RA (mean age 54.7 years, 18,688 [77.5%] women) were analyzed. Ambient respiratory viral infections in the population were associated with a higher number of incident RA over time, and its effect peaked 6 or 7 weeks after exposure. Among the 8 viruses, parainfluenza virus (4.8% for 1% respiratory viral infection increase, 95% CI 1.6 to 8.1, P = .003), coronavirus (9.2%, 3.9 to 14.8, P < .001), and metapneumovirus (44%, 2.0 to 103.4, P = .038) were associated with increased number of incident RA. The impact of these respiratory viral infections remained significant in women (3.8%, 12.1%, and 67.4%, respectively, P < .05) and in older patients (10.7%, 14.6%, and 118.2%, respectively, P < .05). Conclusions Ambient respiratory viral infections in the population were associated with an increased number of incident RA, especially in women and older patients, suggesting that respiratory viral infections can be a novel environmental risk factor for the development of RA